LTR-3

Where the unit is to be installed in an attic or concealed location, the choice is the LTR-3. LTR-3 contains the same technology as the Pingvin unit, but is finished in galvanised steel sheet.

This unit is usually installed in the attic. With additional insulation the unit can even be installed in an attic without heating. Bag filters of class EU7 are available for this unit.

The LTR units are now available with the new ECC05 Electronic Climate Control System, adding advanced functionality to the system. For more information click here

Design Guide + O&M

Detailed design guide with operation and maintenance instructions for the LTR 3EC and ECE can be found here

LTR-3

Enervent LTR-3

Control
4-speed regulation, an on/off-switch for the heat recovery and the models with electrical heaters have regulation of the heating.
Fan power
LTR-3-85: 130 W
LTR-3-120: 185 W
Heater
E-models:
Built-in 500 W electrical heater with a capillary thermostat
EP-models:
Built-in 500 W electrical heater with a Pulser Triac controller and a duct temperature sensor
Filters
Supply air: EU5 plain filter
Exhaust air: EU5 plain filter

Read more

Enervent LTR-3 AC
Control LTR-3-AC is controlled with the built-in AC-automation. Press the headline for more information about the automation. Fan power LTR-3-AC 185 W Heater ACE-models: Built-in 500 W electrical heater with over-heating protection ACW-models: Water heater Ø 160 mm, for installation in the duct Filters Supply air: EU5 plain filter Exhaust air: EU5 plain filter Read more

[main page]